The RC Lander T-33 Arf features Super EPO foam construction with detailed panel lines in a classic popular design. The T-33 comes completly painted with decals that can be applied for added realism.  Construction features of the T-33 include a reinforced wing and fuselage that are specifically designed for high G maneuvers. Made of durable yet light weight Super EPO foam, allows easy repairs in the event of damage done to the airframe.  Building time is kept down to just a few hours to complete the jet and get it in the air.  The jet is designed to be taken off from the ground whether it is a paved runway or on a maintained grass field. The T-33 is a fully aerobatic capable jet where loops, axial rolls, knife edges, stall turns, spins, hammerheads and inverted flight make this jet a dream to fly.  Flight times are estimated to be between 5 to 10 minutes in length depending upon the motor and battery chosen.  This edf jet is designed with the experienced pilot in mind.

SPECIFICATOINS:

• Wingspan: 64.5 Inches/ 1638mm
• Length: 59.8 Inches/ 1520mm
• Flying Weight: 8.1 lbs/ 130.5 oz/ 3700g and up

REQUIRED ITEMS:

BUILDERS NOTE: REFER TO THE "ELECTRIC SETUP GUIDELINE" ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.

• Landing gear system: None Included- Recommended RC Lander T-33 Electric Retract Landing gear. Plug in and go.
• Full scale flaps factory installed: Requires 2 servo
• Drive System Required: EDF 90mm to 120mm Ducted Fan with modification to mounting ring if using larger than a 90mm edf.  It will require the builder to cut away foam out of the ring. Brushless Motor that puts out 42,000 rpm or more. Kit comes with adaptor for a 90 edf unit.  It can be modified to fit up to 120mm fan.
• Servo Required: 8X 9g high speed micro servos
• 2X Servo "Y" connectors: (Ailerons, Flaps)
• 1x Servo "Y" Reverser for Elevator
• 7X 24 Inch Servo Extensions:(Ailerons, Flaps, Elevator, Rudder)
• 5X 18 Inch Servo Extension:(Retracts, Steering, Throttle)
• 2x 1 foot black silicone wire: (Esc to battery connector)
• 2x 1 foot red silicone wire: (Esc to battery connector)
• Speed Controller: Brushless esc that can handle the specific amp output of the brushless motor and lipo cell count.
• BEC: Castle Creations BEC or BEC Pro dependant upon the lipo battery cell count.
• Battery Required: 30C or higher discharge rate and a 4,000 to 5,000 mah lipo.  Cell count will depend upon motor selected.
• Control system Required: 7 CH Multifunctional Transmitter and 7 CH Micro Receiver

RC Lander 90mm 9S DPS EDF Unit Video:

RC Lander DPS 120mm 12S EDF Unit Video: