Designed for EDF jets up to 1600 grams. Suitable for HET EDF unit 6904 or WeMoTec 480 mini fan. This motor is to run on a 6S Li-Po only.
BUILDERS NOTE: REFER TO THE "ELECTRIC SETUP GUIDELINE" ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.
- Diameter: 28 mm
- Length: 48 mm
- Shaft Dia.: 4 mm
- Li-Po: 6S
- Weight: 110 grams
- No load current(lo): 2.2
- Internal resistance: 0.015
- KV: 2660
- No. of poles: 6
- Max Current: 70 A
- Max efficiency: 87%
- Power Nominal: 1100 Watts on 6 cells
- Recommended Props: HET 6904 EDF or APC E 4.7 X 4.7 (4S Only)
Advance timing : 18° Middle PWM: 16 Khz
WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.